Objective: TO Design and Fabrication of Protection Guards to the Bulb.

Materials:

  1. Cutter
  2. Rolling Machine
  3. Hand Cutter
  4. Pliers
  5. Hammer

Procedure:

  1. Firstly select the material for fabrication of guards for bulb which is metal wire mesh.
  2. After that cut the metal wire mesh into the proper dimensions by cutter.
  3. Then bend this metal wire mesh in the Rolling or Bending machine.
  4. Cut the upper side horizontal metal wire as showing in the figure by cutter.
  5. Then after bending two sides of metal wire mesh are close to each other and join them by single metal wire by Pliers.
  6. Press the upper vertical metal wire inside of frame.
  7. At the below or bottom side there is door is provide of metal wire mesh of its opening size.