1. The gate should open effortlessly when a button is switched on.
  2. The gate should open using the weight of the water inside a container. If the container reaches a certain weight, the gate will automatically open.
  3. The gate should produce a sound, like a buzzer while opening or closing. This is to ensure that the gate’s movement is noticeable and not abrupt, preventing any harm to anyone nearby.

3/12/23

this project was handoverd by himanshu sir to me

when i had observed the main gate is not in good working condition

the defects are ;1. the water pipe is broken

2.current supply is not working

3.the water container is having a hole

4.obsession sheet of the water container is damaged

5.motor pump is full of dust

solutions of thre problems

1.i had replaced a good quality pipe

2.with the help of the electrical boys i had updated two switches for controlling the gate

3.by using the glue gun and water proof tape i covered the hole of water container

4. i done paint coting instead of using obsession sheet

5 i had cleaned the motor pump mainly the inlet nd outlet valves

4/12/23

the main problem is water were not entering into the water container and pipe is not fixed properly ,so i had used a hard piece of plastic pipe at the top of the water container so that the water can easily go into the water chamber and binded water pipe the chamber and the water supplier chamber is out so that it can damaged nd motor pump can also be damaged so i had a slot for supplier chamber nd covered it with polycarbonate sheet

5/12/23

done painting of the gate