16/9/24
Helped tejasvini didi for temperature analysis. Readings from different places inside and outside the polyhouse were taken for 15-15 min. Thermo – hygro meter, Anemometer was used to take readings.
27/9/24 – 29/9/24
Recorded data by creating certain conditions inside the polyhouse.First of all, at 10 am, the fan pad in the polyhouse was turned off, after the temperature rose to 37 degrees, the fogger system was turned on and we waited for the humidity to reach 80%. The fogger system is turned off after humidity reaches 80%. Then after an hour the fan pad system was turned on again and its readings were taken digitally on the data logger, and with them the light intensity outside the polyhouse was measured using a lux meter.
Welding
Prasad sir asked us to make a stool for welding assignment. Made a drawing of the stool and did all the calculations for the stool.The calculations are as follows:
Load = weight* acceleration
= 529.14*9.81=529.14 N
