Drawing/Sketch:-
Drawing /Measurements:-
Bill of Materials:-
| SR. NO | Materials | Unit | Qty | Cost |
| 1 | Square Tube ( 40x40x3 mm ) | NOS | 2 | 1,200 |
| 2 | Plastic Bucket ( 5 litter ) | NOS | 5 | 500 |
| 3 | Submersible Tillu Pump ( 55 Watt ) | NOS | 1 | 750 |
| 4 | Dripper Pipe ( 12 ft. ) | Meter | 1 | 150 |
| 5 | Plastic elbow ( 16 mm diameter ) | NOS | 3 | 75 |
| 6 | Plastic T (16 mm diameter ) | NOS | 4 | 120 |
| 7 | Water tant ( 50 letters) | NOS | 1 | 1,000 |
| 8 | On off timer (230 volts and 30 amp ) | NOS | 1 | 850 |
| 9 | Black drip rubber ( 16mm diameter ) | NOS | 5 | 50 |
| 10 | Black oil paint | liter | 1 | 350 |
Description of Materials:-
- Ground Base:-
- Assembly: Clear the surface below and make it flat. The water level at the ends on the boundary should be 0.
- Dimensions: W=
- Hydroponic Stand:-
- Make a rectangular frame of dimensions = 2286 mm x 300 mm
- Connect four legs of 450mm at the bottom, at an angle (pointing outside)
- Add supporting structure for the buckets, at a distance of 380 mm from each other.
- Lastly, weld an “I” shaped structure at the bottom with dimensions = 413.34 mm x 2100 mm
- Paint the structure
- Plastic Bucket:-
- Purchase five market available buckets of height = 200 mm and diameter = 200mm
- Make a 16 mm hole at the bottom of each bucket
- Add small pieces of bricks and coarse sand before planting the sapling inside the bucket
- Water Tank:-
- To store water for the system, a 50 L tank must be kept on the ground, below the bucket levels.
- Submersible Pump (Tillu ):-
- Insert a submersible pump at the bottom.
- Specification: 220V, 55 watt
- This will allow easy flooding as well as draining of the system.
- Dripper Pipe:-
- Connect 16mm x 12ft dripper pipes to the pump and the bucket to flood and drain the system.
- Plastic T:-
- To multiplex the single channel coming from the pump into 5 channels, attach 4 T connectors in the center
- Plastic Elbow:-
- To connect the ends of the dripper pipe use elbow connections.
- Black Drip Rubber:-
- To prevent leakage of water from the bucket, attach black drip rubber to the hole in the bottom and insert the pipe into it.
- On off timer:-
- The system runs in a cycle of flood and drain, so the pump should be switched on and off.
Fabrication:-
- Material processing
- Welding fabrication
- Painting
- Plumbing
- Electrical supply
Installation:-
