Introduction

Water Brazer is a system designed for efficient water management and controlled supply of water.

  • This project is a water tank buzzer system.
  • It alerts when the water tank is full.
  • Uses a small 5V buzzer and simple circuit.
  • Helps prevent water overflow and save water.

Objective

  • To make a simple device that detects full water tank.
  • To save water by preventing overflow.
  • To learn basic electronics and circuit connections.

Materials

  1. 5V charger / adapter
  2. Small buzzer
  3. Two copper wires (as sensors)
  4. Connecting wires
  5. Tape / insulation
  6. Beaker

14 February – 23 February

Procedure / Steps

  1. Collect all materials.
  2. Connect the buzzer to the 5V charger.
  3. Attach two copper wires as sensor in the water tank.
  4. Complete the circuit with positive and negative connections.
  5. Fill the tank with water to test.
  6. Observe the buzzer ringing when water touches both wires.
  7. Adjust wire positions if needed for correct water level alert.

Conclusion (Water Buzzer Project)

  • In this project, a 5V 1A charger is used to power a small buzzer. Two sensor wires are placed in the water tank, and when the water reaches the wires, it completes the circuit. As a result, the buzzer rings automatically, alerting that the tank is full. This simple setup helps prevent water overflow and demonstrates the practical use of basic electronics.
  • I have successfully installed the first model of my Water Buzzer project on(23 february 2026 ) the DIC water tank. This serves as my first practical experiment,